Add instructions for cap holder

Signed-off-by: Mattias Andrée <m@maandree.se>

1 files changed, 22 insertions, 0 deletions

diff --git a/cap-holder b/cap-holder
new file mode 100644
index 0000000..8d52890
--- /dev/null
+++ b/cap-holder
@@ -0,0 +1,22 @@
+Cap holder for belt
+
+Functionally similar to a carabiner.
+(You can just as well use a carabiner.)
+
+Make a leather strip that's about 1,5 cm wide and 25–27 cm long.
+
+This strip loops around the belts just above two times.
+Start just below the top of the backside of the belt and loop it around the belt.
+
+Use two revits to join the two layers behind the belt.
+As an (untested) alternative, you could use push button to allow it to be
+move around more or removed without removing your belt.
+
+Make sure you have enough slack on the front side for the
+cap's strip, then add a push button to join the two layers
+on the front side.
+
+The remainder of the strip is tucked away behind the belt.
+If you only made the strip 22 cm long, you would have enought
+extra after the push button to easly open it without having
+to tuck it away behind the belt.